Sti 9625 Bedienungsanleitung PDF herunterladen

Safety Technology International, Inc.

306 Airport Road • Waterford, Michigan 48327-1209

Phone: 248-673-9898 • Fax: 248-673-1246

Toll Free: 800-888-4784 • E-mail: info@sti-usa.com

Web: www.sti-usa.com

Safety Technology International (Europe) Ltd.

nit 49G Pipers Road • Park Farm Industrial Estate • Redditch

orcestershire • B98 0HU • England • Tel: 44 (0) 1527 520 999

Fax: 44 (0) 1527 501 999 • Freephone: 0800 085 1678 (UK only)

E-mail: [email protected] • Web: www.sti-europe.com

IMPORTANT:

Do not attempt to install detector guards until both the transmitter and receiver

have been perfectly aligned and tested. Lag shields are for use in concrete and

the mortar joints of block or brick walls. For wood installations drill pilot holes

13/64” diameter for lag screws only. Lag shields are not required for this type

of installation. Do not install guard on hollow backed drywall.

SERVICE

When servicing, remove the center lag screw on top of the guard then loosen

the other (5). The guard may now be slid upward and removed. Use caution

not to hit or bump the detectors or misalignment may occur.

INSTALLATION INSTRUCTIONS

1. After alignment center the wire guard over existing System Sensor smoke

beam. Slots must have openings facing downward as shown.

2. Use the guard as template with the center mounting hole and (2) slots on

top (as shown). Position guard to allow projected beam to pass through

one of the 1 1/2 in. grid openings.

3. Mark and drill (6) 1/2 in. diameter holes 1 1/2 in. deep.

NOTE: If after installation, interference of the projected beam is passing to

close to one of the wire struts, the interfering strut may be cut and

removed without structural weakening or loss of warranty.

INSTALLATION OF STI BEAM SMOKE DAMAGE STOPPER STI-9625

All specifications and information shown were current as of publication and are subject to change without notice.

9625 MARCH2013

SIDE VIEW

.875 in.

(200mm)

TOP VIEW

2.625 in.

(321mm)

10.25 in.

(

260mm)

19006 LAG SHIELDS

1/4 in. x 1 1/2 in.

(

6) PROVIDED

19005 LAG SCREW

1/4 in. x 1 3/4 in.

(6) PROVIDED

EXISTING 6424 SYSTEM

SENSOR SMOKE BEAM

APPROVALS

UL/cUL Listed (No. S3504) for use with System Sensor beam detector model 6242.

Electronic warranty form at www.sti-usa.com/wc14

1 2

Inhaltsverzeichnis

Seite 1

Safety Technology International, Inc.2306 Airport Road • Waterford, Michigan 48327-1209Phone: 248-673-9898 • Fax: 248-673-1246Toll Free: 800-888-4784

Seite 2

SMOKE DETECTOR COVERSSTI-9601 Low profile - Flush mountSTI-9601-SS Low profile - Flush mount -Stainless Steel

Kommentare zu diesen Handbüchern

Keine Kommentare

Sti 9625 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Sicherheit Sti 9625 herunter. STI 9625 User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheit Sti 9625